Hase Como - Manual (Page 35)

35
8. Heating with Brown Coal Briquettes
Wood should be used for the warming-up phase
and when adding fuel for the fi rst time, see “Warm-
ing-up Phase”. As soon as a basic glowing fi rebed
is reached, place 2-3 brown coal briquettes on the
grate in the middle of the fi rebox, keeping a fi nger’s
width between the briquettes, and use the following
procedure and settings:
Heating with Brown Coal Briquettes
Procedure Position of
Control Elements
Open primary air com-
pletely.
Adjust secondary air.
Pull primary air slider all
the way out (fi g. 5)
Set secondary air slider
to position 2. (fi g. 5)
Place 2 briquettes onto
the grate.
Open fi re grate. Pull out fi re grate slider.
Tab. 3
fi g. 5
(I)
(II)
9. Banking the Fire and Raising the
Temperature
Keep the stove set as described above until the
brown coal briquettes are thoroughly burnt. Then
close the primary air (I) and the fi re grate. Slide the
secondary air slider (II) to position 2/3.
CAUTION!
While the stove is in operation, the sec-
ondary air slider should never be com-
pletely closed.
To raise the temperature of the fi re, stir up the rest
of the glowing embers with the fi re grate slider.
Open the primary air (I) and add new logs to the
fi re.
7. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the fi re when the
fl ames from the previous burning off phase have
just gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and
secondary air. Close primary air slider
(I), set secondary air
slider (II) between posi-
tion 2 and 3. (fi g. 4)
Close fi re grate. Push in fi re grate slider.
Add two logs weighing
approx. 1,7 kg in total.
Place logs with one end
to the front of fi re box.
Only add a single layer
of fuel.
Tab. 2
fi g. 4
(I)
(II)