Trouble- shooting, Warning – Desa A User Manual

Page 31

Advertising
background image

31

101048

TROUBLE-

SHOOTING

Continued

WARNING ICON

G 001

WARNING

If you smell gas

• Shut off gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not

use any phone in your building.

• Immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s
instructions.

• If you cannot reach your gas supplier, call

the fire department.

IMPORTANT:

Operating heater where impurities in air exist may create odors.

Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new
carpet or textiles, etc., create fumes. These fumes may mix with combustion air and
create odors.

POSSIBLE
CAUSE

1. Metal expanding while

heating or contracting
while cooling

1. Heater burning vapors

from paint, hair spray,
glues, etc. (See

IMPORTANT

statement

above)

2. Low fuel supply
3. Gas leak.

See Warn-

ing statement at
top of page

1. Not enough fresh air is

available

2. Low line pressure

3. ODS/pilot is partially

clogged

1. Gas leak.

See Warn-

ing statement at
top of page

2. Control valve defective

1. Foreign matter be-

tween control valve
and burner

2. Gas leak.

See Warn-

ing statement at
top of page

OBSERVED
PROBLEM

Heater produces a
clicking/ticking noise
just after burner is lit
or shut off

Heater produces
unwanted odors

Heater shuts off in
use (ODS operates)

Gas odor even when
control knob is in
OFF position

Gas odor during
combustion

REMEDY

1. This is common with

most heaters. If noise is
excessive, contact
qualified service person

1. Ventilate room. Stop

using odor causing
products while heater is
running

2. Refill supply tank
3. Locate and correct all

leaks (see Checking Gas
Connections
, page 21)

1. Open window and/or

door for ventilation

2. Contact local propane

gas company

3. Clean ODS/pilot (see

Cleaning and Mainte-
nance
, page 28)

1. Locate and correct all

leaks (see Checking Gas
Connections
, page 21)

2. Replace control valve

1. Take apart gas tubing

and remove foreign
matter

2. Locate and correct all

leaks (see Checking
Gas Connections
,
page 21)

Advertising