HITEC Optic 5 2.4 - Manual (Page 11)

Page 10
The ATV function is somewhat similar to EPA (End Point Adjustment) and D/R (Dual Rate) function; it allows you to adjust a servo’s travel end positio
amount over a control stick‘s movement.
The ATV function affects both endpoints at once, while the EPA function allows each servo end to travel individually.
This function can be found useful when the plane is too sensitive over a control stick’s movement.
"ATV" potentiometer
The Link button can be used for the Link (ID setting) process between the Optic 5 radio and Hitec 2.4GHz receivers, entering the power down
mode for range check, activating SmartScan function and using Fail-safe function. The LED indicator shows current working status of the radio
with both red and blue lights. For more detailed information, please read pages13~16.
"LINK" button and LED Indicator
The DATA port is designed with a 3-pin type. Through the HPP-22 Hitec PC program, you can down load the firmware program and software
upgrade. In addition, you can monitor the sensor data with the voice solutions and set up a low voltage receiver alarm. *
"Sensor Data Output and System Upgrade Connector” Port
* The Minima 6T and 6E are designed for a single direction from the transmitter to the receiver, so you CAN NOT use all other sensors
(including the receiver’s voltage sensor).
However, if you use the Optima 6, Optima 7 or Optima 9 receivers and connect your PC with the HPP-22 and Optic 5 together, then you can
check sensor values on the PC screen. You can also hear the sensor data and warnings through the HTS-VOICE.
The Mixing switch is used for mixing the function of servos with different wing types. ( V-TAIL and ELEVON )
"Mixing ( V-TAIL and ELEVON )" slide switch
The REV switch is used for reversing the direction of the servos.
"REV (Servo Reverse)” slide switch
Optic 5 2.4 Programming Switches and Buttons
On-Off Switch
5
5
This switch does more than just turn the radio on and off, it also allows you to link to the receivers (see page 13).