HITEC Optic 5 2.4 - Manual (Page 18)

Page 17
5
5
Receiver-Servo Connection List
Set-up and Use of the Hitec 2.4GHz System
Receiver-Servo Connection List W/ OPTIC 5 2.4
The table below shows where the aircraft's servos should plug into a six-channel receiver. Note that some functions shown will not operate
until they are activated in the transmitter. The standard function is listed first for each channel.
- Binding must be done within 15ft. (5m) of the transmitter and receiver.
- The Transmitter and receiver need to be at least 18in. (45cm) from each other to bind properly.
- In the ScanMode, if the transmitter or receiver has been shut off or disconnected for more than one second,
both the module and receiver need to be re-booted (turn the power off and back on).
Note : Both the module and receiver need to re-boot (turn the power off and back on).
50Cm(18in) 5M(15ft)
MAX RANGE
MIN RANGE
RX CH ACRO(Normal) ACRO(Elevon) ACRO(V-Tail)
Landing gear