Home Easy HE306 - Manual

RE-INVENTING THE HOME
HOME
easy
HE-306
Home Easy Plug-In
Door Chime
V1.0
Installation Guide:
The HE-306 Plug-in Door Chime adds extra
control to your HomeEasy products.
When the bell push is pressed a wire free
signal is sent to the plug-in door chime,
activating the "Ding Dong" alert and a
selectable light setting. The operating
range of the HE-306 is up to 40metres
(open distance), allowing you to plug the
chime unit into virtually any socket in the
home.
Important: mounting the bell push unit onto a UPVC door frame or metal surface will
reduce the operating range and may cause the units to work intermittently.
2. Unclip the cover from the bell push and using the 2 holes on the back of the Bell
Push casing as a template (pierce holes as required), mark and drill the fixing holes
and then attach the bell push using the screws provided.
Learn
The transmission range of the wire free signal can be reduced if the signal is
transmitted through a number of walls or ceilings. Metal surfaces and UPVC door
frames can also affect the operating range.
easy
HOME
1. The bell push can be attached to the door frame or adjacent brick surface using
either the self adhesive tabs or using screws & wall plugs provided.
Self Adhesive Strips: make sure the surface is free from dirt and grease. Remove the
protective strips form the back of the bell push and push firmly against the door
frame or wall.
Self Adhesive Strips
3. When the bell push is pressed, the plug-in door
chime receiver will sound and switch the socket
"On" for between 2min and 20min. Ideal for
switching on table light for added security
(Incandescent lighting only).
Setup :
When the bell push is pressed, the plug-in door chime receiver will sound alert and
switch the On socket for between 2min and 20min.
Ideal for switching on table light for added
security (Incandesent lighting only).
Plug the plug-in chine into a standard 3
pin socket and switch the power on, the
chime unit now needs to be paired with
the bell push
(See Pairing/Deleting Bell Push &
Chime).
The plug-in chime has 7 timer settings and one visual alert. Using a small
screwdriver rotate the dial on the back of the plug-in chime to select the
required time.
Visual Alert
- Socket switch On/Off 4 times
Timer Settings
2M - 2minutes
4M - 4 minutes
6M - 6 minutes
8M - 8 minutes
10M - 10 minutes
15M - 15 minutes
20M - 20 minutes
Timer Select
The chime will always make a "Ding Dong" sound
when the bell push is pressed.