Home Easy HE413 - Manual

RE-INVENTING THE HOME
HOME
easy
HE-413 Remote control
Outdoor PIR & Socket
V1.0
Installation:
The HE-413 Outdoor PIR Kit adds extra security and ease
of use to your Home Easy products
PIR:
-Selectable timer setting
-10Metre Detection Range
-IP44 Weather Proof
-25 Metre Wire Free Range
-Battery Powered 3*AAA
Socket:
-3000W Load Max
-Indoor use only
The HE-413 allows you to control your HomeEasy Receiver sockets or modules
via a wire free remote control PIR sensor.
When the PIR beam is broken the outdoor PIR will switch on your Remote
control socket for between 15 seconds and 4 Minutes.
Ideal for controlling out door lighting, staircase lighting and house hold
lighting for added security.
Compatible with all HomeEasy products.
1. Fist select your required location, it's recommended that the PIR is installed
approximately 3 metres off the ground (ideally under the eaves of the building)
and, away form direct sources of sunlight or heat.
Warning: Avoid installing the Remote Control PIR onto metallic surfaces
and above heating vents as this will affect the operating performance.
2. Remove the PIR unit form the base and using the mounting bracket as a
template mark and drill appropriate holes and fix the bracket securely using
the appropriate screws and wall plugs (included).
1. Unclip the battery cover from the bottom of the
PIR using a small screw driver.
Changing Batteries:
2. Remove the batteries and replace using 3
new 'AAA' batteries, making sure the polarity
is correct.
Always dispose of old batteries in an
environmentally responsible way
3. Replace the battery cover making sure the rubber seal is correctly
aligned and firmly push the case together.
Rubber seal
Avoid Direct Heat
Sources
Detection Distance
easy
HOME
r rr