Imaxrc B606-AC-PRO - Manual (Page 12)

NiMH/NiCd battery program
Press key to the screen on the left, and then press key to into the
submenu. You can switch at the same level menu to select the mode by Key.
Please refer the detailed flow chart on the left. When you are willing to alter the
parameter value in the program, press key to make it blink, then change the
value with key. The value will be stored by pressing key once. Then
press key for more than 2 seconds to start the process. Since the menu of NiMH
is the same as NiCd, there is an example of NiMH only.
“CHARGE” mode the default mode is “AUT”. In “AUT” mode,you need to set the
upper limit of charger current to avoid from higher feeding current that may damage
the battery. Because some batteries of low impedance and small capacity can lead to
the higher charge current by the processor at automatic charge mode. But in “Man”
mode, it will charge the battery with the charge current you set at the display. Each
mode can be switched by pressing start/enter key, when the current field is blinking,
press key for more than 1 second.
“DISCHARGE” mode the discharge current ranges from 0,1A to 5.0A and the final
voltage ranges from 0.1 to 5.0A and the final voltage ranges from 0.1 to 25.0V, the
operating method similar as Lithium battery. The final voltage of NiMH battery is
1.0V/Cell, and the NiCd is 0.85V/cell, please refer the recommend by the battery of
manufacturer.
“CYCLE” mode this charger can perform 1-5 cycles of DCHG>CHG or CHG>DCHG
continually. You can select it for the new NI** battery or the long-term placement
NI** battery. Please set up carefully or it will damage the battery! To set the
parameter please follow the previous charge/discharge menu.
Mode
Esc
Enter
start
Enter
start
Dec./Inc.
Enter
start
Dec./Inc.
Dec./Inc.
Enter
start
Enter
start

PROGRAM SELECT
NiMH BATT
NiMH CHARGE Aut
CUR LIMIT 5.0A
NiMH DISCHARGE
1.0A 11.5V
NiMH CYCLE
DCHG CHG 3
v
Mode/Esc
Enter/Start
Dec.
Dec.
Inc.
Dec.
Inc.
Inc.