Dual XHDR6435 - Manual (Page 25)

25
XHDR6435 OPERATION
Bluetooth
®
Operation (BTM60)
Overview
Connecting a Bluetooth device requires first installing and connecting the Dual BTM60
Bluetooth interface module (sold separately). When connected to a Dual Bluetooth ready
head unit, the BTM60 supports the HFP (hands-free profile), A2DP (advanced audio
distribution profile) and AVRCP (audio video remote control profile).
Preparation
Before you can use a mobile device with this head unit, it must be paired and connected.
Please make sure that Bluetooth is activated on your mobile device before you begin the
pairing process. Refer to the owner's manual of your mobile device for more details.
Bluetooth Pairing
1) To pair a Bluetooth enabled mobile phone to the BTM60, change to Bluetooth mode by
pressing on the head unit or press MODE until "BLUE-TOOTH" is displayed.
2) Press and hold on the head unit or BTM60 for 5 seconds, until "PAIRING" is
displayed, the Bluetooth icon will flash every second. The head unit will begin to
broadcast the pairing signal for 90 seconds.
3) Complete the pairing from the Bluetooth menu of your mobile device by searching
for new devices. Please refer to your mobile device instructions for further information
on Bluetooth pairing and connections. The Bluetooth icon will illuminate solid when
connected.
The BTM60 device name is "DUAL_BTM60."
The Bluetooth passcode is 1234.
Compatibility
• Due to the differences in Bluetooth technology, some mobile devices may be
incompatible or function improperly when used with the BTM60.
Connecting a Mobile Device
• If the AUTO-CON menu setting is set to OFF, you must press to connect your device
after pairing.
• From Bluetooth standby mode, press and hold
to disconnect your mobile device
from the BTM60.
• If your mobile device becomes disconnected, press from Bluetooth standby mode to
reconnect your mobile device to the BTM60.
• To connect a previously paired mobile device:
1) Disconnect any mobile devices by pressing and holding for 5 seconds.
2) Press SELECT. "DEVICE NAME" will appear on the LCD.
2) Turn the volume knob to cycle through the list of devices 1 through 8.
3) Press SELECT to connect to the desired device. It must be in range to connect.
Note: When a device number is selected, it will take a few moments for the device name
to appear on the bottom line of the LCD.