JUGS Sports PS50 Pitching Machine - Manual (Page 15)

▲
• C arefully lift machine from carton and place on level surface .
• Make sure you have all the parts (See Figure 3 and 4 on pages 10 and 11) . If
any parts are missing, do not operate the machine until the missing parts are
replaced . Failure to do so could result in possible serious personal injury .
• Do not discard the packing materials until you have carefully inspected the
machine, identified all the parts, and satisfactorily operated the machine .
NOTE: If any parts are damaged or missing, do not attempt to plug in the
power cord and turn on switch until the damaged or missing parts are obtained
and are installed correctly .
13
! WARNING: To prevent accidental starting or electrical shock that could
cause possible serious injury, assemble all parts to your
machine before connecting it to the power supply. The
pitching machine should never be connected to a power
supply when you are assembling parts, making adjustments,
cleaning, servicing, or when not in use.
Unpacking
for baseball Use: The JUGS PS50 comes assembled for baseball use .
1 . Assemble legs as explained on page 12, baseball Leg Assembly (shown in
figure 3, page 10) .
2 . Tighten T-Handle hand-tight .
for Softball Use:
1 .
Remove pad bracket bolts with 1/2" wrench and move pad bracket to upper
holes (Softball Position) . Reinstall and tighten pad bracket bolts (always from
control side of machine) .
Set Up