JUGS Sports Field General Football Machine - Manual (Page 8)

Transport
The JUGS FIELD GENERAL ™ Football Passing Machine can be moved
quickly and easily by using the black Transport Tire.
1. Make sure the FIELD GENERAL ™ is turned off and the wheels are
NOT spinning.
2. Remove the Passing/Punting Slide from the machine.
3. Loosen the Elevating T-Clamp and rotate the Motor Mount Assembly
completely back. Tighten the Elevating T-Clamp.
4. Slowly tip the machine over, onto the black tire.
front of the machine as shown below.
•
Do not use the white ball-throwing wheels for
moving this machine.
WARNING: Never leave machine unattended.
13
1. With the tire-side down, place the triangular leg clamp in the leg clamp
casting.
2. Insert the threaded end of the Leg T-Clamp through the center hole in
the leg-clamp casting and start the threads.
3. Install one leg in each round hole in the center piece of the leg clamp
casting. Tighten the Leg T-Clamp sufficiently to hold the legs in place
very snugly.
4. Place the crutch tips on the lower end of the legs if your JUGS machine
is to be used indoors. The crutch tips are not recommended for outdoor
use.
5. Lift the football machine upright and onto its legs.
IMPORTANT:
Always set up the machine so that two legs are positioned in front,
facing the target, and one leg facing back toward the operator.
1. Check the speed dial and make sure it is in the full counter-clockwise
position (pointer at the “0” setting) and the toggle switch is in the OFF
position.
2. Plug a heavy-duty, No.-16-gauge three-prong, extension cord into a
110-volt (or 220-volt if applicable) GFCI outlet and connect it to the
short cord on the pitching machine.
3. Loosen the Horizontal T-Clamp and position the machine to aim at
the desired target. Re-tighten the T-Clamp. Adjust the desired ball
trajectory by using the Elevating T-Clamp. (You will have to
practice this targeting to learn how to set the machine for each pass).
Machine Assembly
12
▲
!