Kent EWD-320 Wet/Dry Vacuums - Manual (Page 6)

6
WARNING!
To reduce the risk of fi re, electric shock, or injury, please read and
follow all safety instructions and caution markings before use. This va-
cuum cleaner is designed to be safe when used for cleaning functions
as specifi ed. Should damage occur to electrical or mechanical parts,
the cleaner and / or accessory should be repaired by a competent
service station or the manufacturer before use in order to avoid further
damage to the machine or physical injury to the user.
• Do not use outdoors.
• Do not leave the machine when it is plugged in. Unplug
from the socket when not in use and before maintenance
• Do not use with damaged cord or plug. To unplug grasp
the plug, not the cord. Do not handle plug or cleaner with
wet hands. Turn off all controls before unplugging.
• Do not pull or carry by cord, use cord as a handle, close a
door on cord, or pull cord around sharp edges or cor ners.
Do not run cleaner over cord. Keep cord away from heated
surfaces.
• Keep hair, loose clothing, fi ngers and all parts of the body
away from ope nings and moving parts. Do not put any
objects into openings or use with opening blocked. Keep
openings free of dust, lint, hair, and anything else that
could re du ce the fl ow of air.
• Do not use to pick up fl ammable or combustible liquids
such as gasoline, or use in areas where they may be pre sent.
• Do not pick up anything that is burning or smoking, such
as cigarettes, mat ches or hot ashes.
• The appliance is not intended for use by young children
or infi rm persons. Young children should be su per vised to
ensure that they do not play with the appliance.
• Use extra care when cleaning on stairs.
• Do not use unless fi lters are fi tted.
• If the cleaner is not working properly or has been dropped,
da
ma ged, left out doors, or dropped into water, re turn it to a
service center or dealer.
• Use only as described in this manual and only with the
manufacturer’s re com men ded attachments.
SAFETY INSTRUCTIONS
THIS VACUUM CLEANER IS DESIGNED FOR COMMERCIAL USE.
ACCIDENTS DUE TO MISUSE CAN ONLY BE PREVENTED BY THOSE USING THE MACHINE.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
NOTE!
Remove the plug from the socket before performing maintenance.
Before using the machine make sure that the frequncy and voltage
shown on the rating plate correspond with the mains voltage.
Specifi cations and details are subject to change without prior
notice. The accessories shown in the pictures may vary from model
to model.
GENERAL INFORMATION
BEFORE YOU PLUG IN YOUR CLEANER, check the rating plate
located on the cleaners back side to see if the rated voltage agrees
within 10% of the voltage available.
DO NOT OIL, the motor in your new cleaner is permanently lubricated
and sealed. Do not oil the motor at any time.
During shipping, the dust bag may have become dislodged. Check
the bag to insure proper seating before attempting to use the cleaner.
Do not operate the cleaner without the fi lters installed as damage may
result to the motor.
The machine is equipped with a thermal breaker to protect the motor
and other vital machine parts from overheating. Should this breaker
open, you will have to wait at least 5-10 minutes before you try to start
it again. While you are waiting, switch the machine off and unplug it,
then check the hose, dust bag and fi lters to be sure that nothing is
blocking the fl ow of air through the machine.
Note! It is neccessary to reset the machine by pressing the on/off
button, the machine will not start again until this is done.
For longer service life and safe use of your vacuum cleaner, we re-
commend the following guidelines: Your cleaner is designed to pick
up dirt and dust particles and water. Avoid picking up hard or sharp
objects with your cleaner to avoid bag breakage, clogging or possible
motor damage.
SERVICE INFORMATION
To obtain consistent performance over the life of your vacuum, read
through these instructions and keep them handy for future reference.
If you require service, contact the dealer from whom the vacuum was
purchased, or the local authorized Service Station. Always refer to
your Service Station for complete service information. For prompt
and complete service information, always refer to the model, type
and serial number indicated on the rating plate.
IMPORTANT!
The machine is equipped with a specially designed cord which if
damaged, must be replaced by a cord of the same type. This is av-
ailable at authorised service centres and dealers and must be
installed by trained personnel.