Kipp&Zonen LOGBOX SD Data Logger - Manual (Page 41)

41
0
Are you sure that you want to erase all logs?!
CAP<Y> = erase, else = quit
Y
ERASED.
OK
F
Save configuration to the memory
U
Setup communication speed for serial line
U
You can use the following baud rates:
300 1200 2400 4800 9600 19200 38400 57600 115200
Switch between them by <SPACE> and confirm by <ENTER>
Baud Rate = 115200
If you type <SPACE> you will roll over mentioned intervals. If you will type <ENTER> you will receive
following response:
FINAL Baud Rate = 115200
I
Setup logging interval
I
You can use the following logging intervals:
1 2 3 4 5 6 10 12 15 20 30 60 minutes, 10 20 30 seconds & FAST
Switch between them by <SPACE> and confirm by <ENTER>
LogInterval = 1 minutes
If you type <SPACE> you will roll over mentioned intervals. If you will type <ENTER> you will receive
following response:
FINAL LogInterval = 1 minutes
V
Setup writing interval on SD card
V
You can use the following SD card WRITTING intervals:
1,2,3,4,5,6,10,12,15,20,30 minutes, 1,2,3,4,5,6,12,24 hours & NEVER
Switch between them by <SPACE> and confirm by <ENTER>
SDWriting = 1 minutes
If you type <SPACE> you will roll over mentioned intervals. If you will type <ENTER> you will receive
following response