Dodge 2009 Challenger SRT8 - Manual (Page 331)

3. Set the parking brake, place the automatic transmis-
sion in PARK (manual transmission in NEUTRAL), and
turn the ignition switch to the LOCK position on both
vehicles.
4. Turn off the heater, radio, and all unnecessary electri-
cal loads.
5. Connect one end of the jumper cable to the remote
jump-start positive battery post (+) in the engine com-
partment. Connect the other end of the same cable to the
positive terminal of the booster battery. Refer to the
following illustration for jump-starting connections.
6. Connect the other cable, first to the negative terminal
of the booster battery and then to the engine ground (-)
of the vehicle with the discharged battery.
Make sure
you have a good contact on the engine ground. Refer to
the following illustration for jump-starting connections.
7. Start the engine in the vehicle that has the booster
battery. Let the engine idle a few minutes. Then, start the
engine in the vehicle with the discharged battery.
NOTE: Refer to
ЉSynchronizing ESPЉ under ЉElectronic
Stability Program Љ in Section 5 if the ESP/BAS light (in
Jump-Starting
WHAT TO DO IN EMERGENCIES 329
6