Labconco Class I Enclosure Models 3980423 - Manual (Page 12)

Product Service 1-800-522-7658 8
C
HAPTER
3
G
ETTING
S
TARTED
Now that the site for your filtered enclosure is properly prepared, you are ready to
unpack, inspect, install, and validate your system. Read this chapter to learn how
to:

Unpack and move the enclosure.

Set up the enclosure with the proper supporting structure and work surface.

Connect to an exhaust system if applicable.

Installation of HEPA and accessory Odor Control carbon filters.

Connect the electrical supply.

Set the face velocity with the speed control adjustment.

Arrange validation for the enclosure.

Seal the enclosure to the work surface.
Depending upon which model you are installing, you may need common
mechanical and electrical installation tools in addition to 5/16", 3/8", 7/16", and
1/2" wrenches, ratchets, sockets, a nut driver set, a flat-blade screwdriver, a
Phillips screwdriver, and a carpenter level to complete the instructions in the
chapter.
Each enclosure model weighs between 125 to 195 lbs. each (55
to 85 kg). The shipping container allows for lifting with a
mechanical lift truck or floor jack. If you must lift the
enclosure manually, follow safe-lifting guidelines.
Do not lift
by the front air foil .
!