Labconco FreeZone Bulk Tray Dryer 78060 Series User Manual
Page 8
Product Service 1-800-522-7658
4
C
C
h
h
a
a
p
p
t
t
e
e
r
r
2
2
:
:
P
P
r
r
e
e
r
r
e
e
q
q
u
u
i
i
s
s
i
i
t
t
e
e
s
s
Before you install your Bulk Tray Dryer, you need to prepare your site for
installation. The Bulk Tray Dryer will mount on top of a FreeZone 6, 12 or 18
liter Freeze Dry System. This could be either a benchtop or console model.
Carefully examine the location where you intend to install your Bulk Tray Dryer.
You must be certain that the area is level and of solid construction. An electrical
source must be located near the installation site.
Carefully read this chapter to learn:
• The electrical supply requirements.
• The vacuum pump requirements.
Refer to Appendix C: Bulk Tray Dryer Specifications for complete Bulk Tray
Dryer electrical and environmental conditions, specifications and requirements.
Refer to the User’s Manual for the FreeZone Freeze Dry System for complete
electrical and environmental conditions, specifications and requirements.
Electrical Requirements
The Bulk Tray Dryer requires a dedicated electrical outlet. This outlet requires a
15 Amp circuit breaker or fuse for models rated at 115V (60 Hz). An outlet
equipped with an 8 Amp circuit breaker or fuse is required for models rated at
230V (50/60 Hz). Various power cord configurations are provided with 230V
models. If this does not match with the available receptacle, remove this plug and
replace it with an approved plug of the suitable style.
Location Requirements
The Freeze Dryer should be located in an area that provides an unobstructed flow
of air around the cabinet. This air cools the refrigeration system. A minimum of
3" must be allowed between the rear and both sides of the Freeze Dryer and
adjacent wall surfaces. Restriction of airflow during operation could adversely
affect performance. Refer to Appendix B: Bulk Tray Dryer Dimensions for
dimensional drawings of the Bulk Tray Dryer.