Lingenfelter L380xx1410 Lingenfelter Camaro Cast 241 MM Aluminum Differential 2010-12 v1.9 - Manual (Page 14)

Page
42. In the following step, the differential vent
hose will be secured to the vehicle using the
supplied M6x20 sheet metal screw with 17mm
washer (PN: 1278) and 3/4” hose clamp (PN:
9386).
43. After inserting the vent tube into the hose
clamp, use an electric drill with a 10mm socket
and the sheet metal screw to secure the clamp
to the vehicle where desired.
13.
41. If you are routing the vent hose up into
the passenger side wheel well (which LPE
recommends), use the supplied zip tie (PN:
23925-X) to secure the hose to the passenger
side rear brake line.
40. After routing the hose into the passenger
side wheel well to check hose length and cutting
the hose down if desired, install the 1/4” breather
vent (PN: 9833K22) onto the other end of the
hose installed in the previous step. Then using
a pair of Oetiker clamp pliers (or equivalent),
install the Oetiker clamp (PN: 52545K71) on
the end of the hose to secure the hose to the
breather vent.