Lingenfelter L450010197 L450020197 Lingenfelter C5 Corvette Battery Relocation v1.5 - Manual (Page 13)

Remove the plastic panel behind the right front tire.
This can be achieved more easily when you take the
tire off.
Remove the stock battery tray from the engine com-
partment, noting that it is bolted from the center out-
ward. Route the cable(s) forward from the rear fender
well until they come out of the front fender well area.
Cable(s) should route above the PCM (Powertrain
Control Module) as shown.
Slide the heat sleeve (part #27) over the positive
cable, using electrical tape or self fusing silicone tape
to secure it. Once the cable(s) have reached the stock
battery location they will take the route of the stock
cables. The supplied heat shield should be used on
the positive (red) cable from the starter lug back. Use
cable ties to secure cable(s) to loom against fire-
wall. Make sure there is adequate clearance between
cable(s) and exhaust manifold. Connect the red wire
(part #3) to the lug on the fuse relay center, it should
appear similar to the stock wire. Both red and black
stock cables should be removed from the vehicle.
Page 12 of 21