Lingenfelter L450080000 Lingenfelter TVS Diode v1.4 - Manual (Page 3)

Installation
Solenoid
Install the TVS diode across the solenoid
wires as close to the solenoid as possible.
Polarity does not matter (Red and Black wires
can go to either solenoid wire). If there is no
accessible ground terminal to connect the
diode to, such as the case with a transbrake
solenoid, the diode should be connected to
the nearest ground source. In the case of the
diode for the trans-brake solenoid, the diode
should be connected to the transmission case
as it will provide a ground path.
Page 3 of 3
L450080000 TVS Diode Instructions v1.4.indd
For additional product installation information and technical support, contact LPE
or your LPE products distributor. You can also find technical support and usage
discussions regarding this product and many other LPE products in our Internet
forums:
http://www.lingenfelter.com/LPEforumfiles
Lingenfelter Performance Engineering
1557 Winchester Road
Decatur, IN 46733
(260) 724-2552
(260) 724-8761 fax
www.lingenfelter.com
LPE recommends using TVS diodes on:
• Nitrous solenoids
• Line-lock solenoids
• Trans-brake solenoids