Lingenfelter L460111410 Lingenfelter Camaro SS Boost A Pump 2010-2014 v1.2 - Manual (Page 14)

Page 13.
42. NOTE: if you are installing the
variable voltage increase adjustment
knob shown to the left, simply connect
the RCA type connector to the back
of the adjustment module as shown,
and install it at any place inside of the
vehicle. Secure the adjustment module
with hook and loop tape or self tapping
screws in an easy to access location.
43. Re-install your negative battery terminal
to your battery and your interior in your trunk
Removed in step 1. Remove your jack and
jackstands and start your vehicle.
You have completed the installation process.
41. connect one end of the vacuum hose to
a manifold vaccuum source. Route the hose
safely away from heat and moving parts and
connect to the 90 degree 1/8 inch nipple. At
this point you should have the bracket and
vacuum line installed, wiring installed and the
cover on the end of the vacuum switch.
40. Install the vacuum switch cover (part #
720-32020A) onto the vacuum switch in the
position shown. Run the wires out of the
opening on the bottom of the cap.