Lingenfelter L460285297 & L460316109 Lingenfelter LNC-TRM Torque Reduction Module v1.2 - Manual (Page 10)

Page 9
Installation:
• Make sure the ignition is off before beginning installation.
• You can mount the LNC-TRM using the supplied hook and loop tape or the supplied self tapping
screws.
• Do NOT mount the LNC-TRM directly on top of the engine or near the exhaust manifolds due to heat
concerns.
• Do NOT mount the LNC-TRM in the line of site of high temperature objects such as exhaust
manifolds, turbine housings etc. If needed, put a heat shield in between the heat source and the
module.
• Do NOT install within 6” of nitrous solenoids or other
devices with strong magnetic fields.
• If you have relocated coil packs, do not run the high
voltage spark plug wires alongside the low voltage coil
pack wires. Keep the wires as far apart as possible and,
if they do have to intersect, have them intersect at right
angles.
• Keep the activation wires and the analog voltage input
wire (purple wire) away from possible sources of
electrical noise (coils, injectors, etc.)
• Disconnect the pack connectors on each side of the engine and then plug the LNC-TRM wiring
harnesses in between on each side. It does not matter which bank of cylinders each side of the LNC-
TRM harness connects to.