LINK Systems Omni II Automatic Setups Module - Manual (Page 65)

October 16, 2008 Manual Version 1.1
A-3
course this data can also be obtained from the cushion manufacturer.
Set Min. Cushion Force to 0.
Set the Max. Pressure to 90 psi. This is the maximum cushion pressure.
Set the Min. Pressure to 2 psi. This is the value that just supports the weight of the cushion
piston and pressure plate.
Set the Tolerance to 2 psi.
Set the Fault Time to 20 seconds.
Set the Transducer Full Scale to 200 psi. Per the specifications listed, the pressure transducer
that we are using has a full scale rating of 200 psi.
Finally, we go back to the Mode line and set the Mode to ON.
See section 5.2 for operation details.
Section A.3 Example Rotary Slide Adjust Configuration
This example assumes the rotary slide adjust system has been wired at “SS1". First, some
information needs to be gathered.
A 100 turn AMCI series dual resolver is mounted on the press slide.
From the nameplate on the press or the press manual, we find that the minimum shut height is
12.500 inches and the maximum shut height is 16.000 inches.
Since the slide adjust rotary transducer and slide adjust motor starter control are wired in at
“SS1", move the cursor to Slide Slot 1. Press the CHANGE SETTING softkey. From the pop-
up menu, select Slide 1 by moving the cursor to Slide 1 and pressing the SELECT softkey. We
have now told the Automatic Setups module that Slide Slot 1 is to control a slide adjust system.
We must now configure all the parameters associated with Slide Slot 1 for the particular press
and rotary transducer.
Press the CONFIGURE SYSTEM softkey. The Slide 1 Configuration menu will appear.
Temporarily set the mode to OFF. We will change this after all other parameters are set.
Set the Shut Height Units to in (inches). After calibration, the units can be changed, if desired.
Set the Upper Limit to 16.000 inches. Per the specifications listed for the maximum shut height.
Set the Lower Limit to 12.500 inches. Per the specification listed for the minimum shut height.