Luxul XAP-1230 - Manual (Page 10)

10
XAP-1230
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XAP-1230 Vers: 07314
simply connect an Ethernet cable to the PoE injector (Power/Data port) and the op-
posite end of the Ethernet cable to the PoE port of the AP. An Ethernet cable length
of up to 100 meters can be used. DO NOT apply power to the PoE injector yet.
NOTE: Category-5, super Category-5 or Category-6 unshielded twisted pair
(CAT5/CAT5e/CAT6 UTP) cables should be used. For best results, it is
recommended that CAT6 shielded twisted pair be used to ensure stable
data transmission at highest data rates.
4.4.4 Connecting to the Internet Source
Note that this Luxul device is not a router and in most installations will be connected
to a Router or Switch in order to deliver Internet access. To do so, connect the PoE
injector to the desired Internet source using another Ethernet cable.
Power
Source
POE
Injector
From your
Router or Switch
XAP-1230
DATA IN
DATA &
PWR OUT
4.4.5 Applying Power
Once the Ethernet cables have been properly connected, connect the power supply to
the PoE injector and plug it in to a standard AC power outlet.
4.4.6 LED Visual Verifi cation
With power applied, you can now verify that the XAP-1230 is connected and function-
ing properly. The Power LED should be on.