Luxul XAP-1230 - Manual (Page 4)

4
XAP-1230
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XAP-1230 Vers: 07314
1 INTRODUCTION
Congratulations on your purchase of the Luxul XAP-1230 - High Power Wireless
Commercial Grade Access Point. The XAP-1230 is designed for use in residential and
commercial Wi-Fi installations—delivering optimal wireless network performance. With
this high powered, single-band wireless access point, wireless devices that are compat-
ible with 802.11b/g/n can sustain high data rates and improved overall performance at
significantly greater distances.
The XAP-1230 features Luxul’s web based management interface. Provides a simple
method for setting up the wireless network. The XAP-1230 is also enabled for instal-
lation simplicity when installed with Luxul Routers, Gigabit Switches, and other Luxul
products.
XAP-1230 Features:
„
Highest FCC Approved Performance (Effective EIRP 36dBm) for Farther Reaching
Signal and Maximum Data Rates
„
Complies with IEEE 802.11n Standard. Backward Compatible with IEEE 802.11b/g
„
Supports WMM QoS Functionality to Prioritize Multimedia Traffic
„
Enhanced Multi-Level Security with WPA-PSK (TKIP, AES, TKIP & AES), WPA2-PSK (AES),
WPA-PSK/WPA2-PSK Personal (TKIP) 64 and 128-bit WEP
„
Supports up to 8 SSIDs - 8 on 2.4GHz Individual Security Settings
„
Multiple SSIDs Support with VLAN Tagging (1 VLAN per SSID)
„
Single Cable Installation with PoE (requires the use of enclosed injector) or
802.at PoE switch/midspan
„
Firmware Upgradeable
„
Easy 3 Step Setup through Web-based User Interface
„
Enabled for Maximum Compatibility and Performance with
other Luxul Products
„
Install on table/desk, Wall or other flat surface
1.1 Warnings
„
Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the XAP-1230 to its power source.
„
Connect all power cords to a properly wired and grounded electrical circuit.
„
Verify that the electrical circuits have appropriate overload protection.
„
Verify there is adequate ventilation around the device, and that ambient
temperatures meet equipment operation specifications.
„
Products outside the approved configurations may be in violation of
Part 15 of the FCC Rules.