Mossberg 715T - Manual (Page 15)

TO DISASSEMBLE THE FIREARM
With a pin punch or similiar tool, remove the two trigger housing retaining pins
located at the side of the receiver (Fig. 12). Be careful not to damage the black
finish on the parts.
While holding the operating handle fully rearward, carefully lift the trigger housing
from the receiver (Fig. 13).
Allow the operating handle to SLOWLY move fully forward. Remove the bolt buffer
from the rear of the receiver (Fig. 14).
Fig. 13
15
Fig. 12
TO DISASSEMBLE THE FIREARM
With a pin punch or similiar tool, remove the two trigger housing retaining pins
located at the side of the receiver (Fig. 12). Be careful not to damage the black
finish on the parts.
While holding the operating handle fully rearward, carefully lift the trigger housing
from the receiver (Fig. 13).
Allow the operating handle to SLOWLY move fully forward. Remove the bolt buffer
from the rear of the receiver (Fig. 14).
Fig. 13
15
Fig. 12
TO DISASSEMBLE THE FIREARM
With a pin punch or similiar tool, remove the two trigger housing retaining pins
located at the side of the receiver (Fig. 12). Be careful not to damage the black
finish on the parts.
While holding the operating handle fully rearward, carefully lift the trigger housing
from the receiver (Fig. 13).
Allow the operating handle to SLOWLY move fully forward. Remove the bolt buffer
from the rear of the receiver (Fig. 14).
Fig. 13
15
Fig. 12
135055_PN 17925 Rev E.indd 15 1/4/13 9:57 AM