NEMO Equipment ESPR 3P - Manual (Page 2)

1
2
3
4
5
6
7
8
9
11
12
10
13
1. Main Poles
2. Ridge Pole
3. Mesh Canopy
4. Swivel Hub
5. Ball Cap Ridge Pole Connector
6. Pole Clips
7. Jake’s Foot Corner Anchors
8. High Splash Guard Floor
9. Mesh Door
10. UVX Window
11. Rear Vent
12. Side Vent
13. Standard Vestibule
ESPRI™ 3P Innovations
1. Pre-bent Pole Configuration: A maximum
volume to weight ratio is achieved using strategic
controlled bends in the aluminum poles. Utilizing
bends in just the right places, this pole set creates
about one and a half times the volume of standard
unbent pole sets of similar weight. Pre-bends are a
very good way to increase your living space without
increasing your burden on the trail.
2. Jake’s Feet: The corner anchor system from DAC
makes tent setup faster and easier. The main poles
attach to the anchors by ball and socket. When the
fly is attached, the Jake’s Feet act as cantilevers
to pull the corners of the inner tent closer to the
ground. The Jake’s Feet also allow you to set up
your fly and poles without the inner tent to create
a convenient tarp/shade shelter.
3. Superior Hardware: Several innovative pieces
of hardware are used to increase the ease of setup
and strength of Espri™ 3P. The Swivel Hub locks the
poles together at the top and Intersection Hubs fix
the front brow pole to the main pole. Jake’s Feet
and acetyl Ballcaps lock the poles to the corners of
the tent. Sliding pole clips make the rest of the tent
setup a snap.