NEMO Equipment HUNKE2P - Manual (Page 3)

®
30”
Insert Trekking Pole
Slide the handle of the trekking pole into the reinforced pocket at
the top of Hunker™ 2P. Extend the trekking pole until the front two
panels are completely tensioned.
Connect Front Anchor
Depending on your configuration, either connect the front (red)
anchor to a tree about 30” high or stake it directly to the ground.
Stake Rear Anchor
Stake the rear anchor creating a full volume shelter and adjust cord at
all anchors so there is even tension over the entire Hunker™ 2P.
Deploy Rain Flap
For extra rain and wind protection, stake the guy line for the grey Rain Flap.
When not in use, you can save a stake point and stow the Rain Flap with snap
closure.
Loosely tension both side anchors to make a triangle of fabric,
and stake in place. Make sure not to over-tension these
corners--more tension can be added at the end of setup.
Stake Side Anchors
Remember to leave no trace. Before leaving your campsite, take a thorough look
around making sure you have not left anything behind, out of place, or damaged.
To contact NEMO Customer Service
Email: [email protected]
Phone: 800-997-9301
HUNKER ™ 2P
INSTRUCTIONS FOR SETUP
1
2
3
4
5
©2013 NEMO Equipment, Inc.