NEMO Equipment MOK - Manual (Page 4)

Seam Seal Lines
(outside tent shell)
Pole Wraps
(12 Total)
APRI™
Attachments
(2 Total)
Pole Clips
(14 Total)
Seam Seal Lines
(outside tent shell)
The Moki™ Link™ enhances the living space
between two Moki™ tents. Use it as a communal
meeting space, versatile entrance, sleeping area for
pets, or covered storage for your wet gear.
Moki™ APRI™ is built for the most brutal conditions
on the planet. It is made from a breathable metal-
ized fabric that reflects body heat and significantly
increases the temperature inside the tent.
Footprints reduce the wear and tear on your tent
floor from contact with the ground. They are made
of 70D abrasion-resistant nylon fabric and perfectly
sized to your tent. The fabric is PU coated for water-
proofness.
Pawprints™ are removable liners perfectly sized to
button snap to the inside corners of your tent. They
protect your tent floor from boots and paws, and
add serious comfort. Pawprints™ are made of soft
brushed polyester.
NOTE: TENT IS NOT FULLY WATERPROOF UNTIL IT
IS SEAM SEALED.
I n some areas of the tent, seams are sewn directly through the
tent shell to create a very strong construction. Water can leak
through these areas so it is necessary to cover the stitching with
Seamgrip®. The Seamgrip® adds strength so you may choose
to apply it to all exterior seams, but it is necessary in the areas
highlighted in red on the diagrams (pole wraps, pole clips, and
APRI™ connections).
Set up the tent and clean any dirt or moisture off the outside
surface. Carefully squeeze the Seamgrip® through the applicator
tip onto the stitching. Use only enough to completely cover the
stitching. Be careful not to contaminate zippers or Velcro®. Allow
at least 24 hours for curing before use. If the Seamgrip® remains
tacky, you can lightly dust the fully cured Seamgrip® with talcum
powder. Cover stiches on the outside of the tent shell.