NEMO Equipment MOT 1P - Manual (Page 5)

INSTRUCTIONS FOR SETUP
Connect Pump
Connect the black valve end of your Integrated Pump to the airbeam
Inflation Valve. You should hear an audible click when your pump is
connected properly.
Stake Corners
Secure the anchors by pounding the stakes into the ground
with a rock or hard object. If the ground is too hard, tie the
anchors to a rock or another heavy object.
Inflate
To inflate the Moto™1P airbeam with the Integrated Pump, blow
into the mouthpiece and squeeze the fabric pouch, repeating
until squeezing becomes difficult and airbeam is rigid.
Tension
Proper tension ensures maximum water shedding and wind resistance.
Once the airbeam is inflated, pull firmly on the adjustable anchors. Add
strut to the Swallowtail end of Moto™1P for better tension and venting.
Locate the black Inflation Valve with protective red cap. If the Deflator
Cap is connected, remove by pressing the metal button and pulling.
This cap can be reconnected to deflate airbeam for storage.
1
2
3
4
5
©2012 NEMO Equipment, Inc.
Locate Valve
Remember to leave no trace. Before leaving your campsite, take a thorough look
around making sure you have not left anything behind, out of place, or damaged.
MOTO ™ 1P
To contact NEMO Customer Service
Email: [email protected]
Phone: 800-997-9301