NEMO Equipment TRANSFORM TAR - Manual (Page 4)

Seam Seal Lines
(outside tent shell)
Seam Seal Lines
(outside tent shell)
Outside Pole
Wraps
(10 Total)
Sleep Tight
Anchor Transfer™
(STAT™)
Vent and Door
Seams
(2 Total)
Pawprints™ are removable liners perfectly sized to
button snap to the inside corners of your tent. They
protect your tent floor from boots and paws, and
add serious comfort. Pawprints™ are made of soft
machine-washable brushed polyester. Place your
sleeping pads between a Pawprint™ and floor to
help them stay in place.
TENSHI™ ACCESSORIES
Sleep Tight Anchor Transfer™ (STAT™) provides
a waterproof, convenient, and direct method of
transferring an anchor into the tent when pitched
on narrow ledges or other high exposure areas.
NOTE: TENT IS NOT FULLY WATERPROOF UNTIL IT
IS SEAM SEALED.
In some areas of the tent, seams are sewn directly through the
tent shell to create a very strong construction. Water can leak
through these areas so it is necessary to cover the stitching
with Seamgrip®. The Seamgrip® also adds strength so you may
choose to apply it to all exterior seams. However, it is only
necessary in the areas highlighted below.
To seam seal your tent, set up the tent and locate the areas
highlighted above. These locations include pole wraps, the
STAT™, and vent seams. Clean any dirt or moisture off the sur-
face. Carefully squeeze the Seamgrip® through the applicator
tip onto the stitching. Use only enough to completely cover the
stitching. Be careful not to contaminate zippers and Velcro®.
Allow at least 24 hours for curing before use. If the Seamgrip®
remains tacky, you can lightly dust the fully cured Seamgrip®
with talcum powder.