NEMO Equipment LOS - Manual (Page 3)

GUARANTEE
NEMO QUALITY RECOMMENDED
INNOVATIONS
NEMO PRODUCT
TECHNOLOGY
POLE SUPPORTED
TECHNOLOGY
AIRSUPPORTED
EXTREME CONDITIONS
EXTREME CONDITIONS POLE SUPPORTED
TECHNOLOGY
EXTREME CONDITIONS
STATISTICS
NEMO PRODUCT
ACCESSORIES
NEMO PRODUCT
®
SETUP GUIDE
NEMO PRODUCT
Note: To easily install the Losi™ Garage™, start with
the fly off the tent.
1. Connect hook around
webbing located at Center
Hub on top of tent.
2. Pass toggles through
thumb loops located at
each end of the same
ridge pole.
3. Insert pole through pole
sleeve and insert ends into
grommets on webbing
strap.
4. Stake out front points.
Stake out side anchors
(optional).
5. Roll back tent fly tucking
it under itself to allow
water to shed off tent and
garage without pooling or
leaking.
1. Connect hook around webbing located at center hub of tent.
2. Pass toggles through thumb loops located at each end of front
ridge pole.
3. Insert pole through ploe sleeve and insert ends into grommets
on webbing strap
4. Stake out front points, side anchors are optional.
5. Roll back tent fly tucking it under itself to allow water to shed off
tent and garage with out pooling or leaking.
1. Connect hook around webbing located at center hub of tent.
2. Pass toggles through thumb loops located at each end of front
ridge pole.
3. Insert pole through ploe sleeve and insert ends into grommets
on webbing strap
4. Stake out front points, side anchors are optional.
5. Roll back tent fly tucking it under itself to allow water to shed off
tent and garage with out pooling or leaking.
1. Connect hook around webbing located at center hub of tent.
2. Pass toggles through thumb loops located at each end of front
ridge pole.
3. Insert pole through ploe sleeve and insert ends into grommets
on webbing strap
4. Stake out front points, side anchors are optional.
5. Roll back tent fly tucking it under itself to allow water to shed off
tent and garage with out pooling or leaking.
1. Connect hook around webbing located at center hub of tent.
2. Pass toggles through thumb loops located at each end of front
ridge pole.
3. Insert pole through ploe sleeve and insert ends into grommets
on webbing strap
4. Stake out front points, side anchors are optional.
5. Roll back tent fly tucking it under itself to allow water to shed off
tent and garage with out pooling or leaking.
1. Connect hook around webbing located at center hub of tent.
2. Pass toggles through thumb loops located at each end of front
ridge pole.
3. Insert pole through ploe sleeve and insert ends into grommets
on webbing strap
4. Stake out front points, side anchors are optional.
5. Roll back tent fly tucking it under itself to allow water to shed off
tent and garage with out pooling or leaking.