NEMO Equipment INTEGRATED PUMP - Manual (Page 2)

WARRANTY
NEMO guarantees every product we sell. We put a great effort into
choosing the best materials and providing you with the highest level of
workmanship. If one of our products does not meet your expectations
during its useful life, we promise to repair it, replace it, exchange it, or
give you a refund at our discretion. NEMO does not warranty products
against normal wear and tear, unauthorized modifications or alterations,
improper use, improper maintenance, misuse or neglect or if the
product is used for a purpose for which it is not intended. Except as
expressly set forth in these terms and conditions, NEMO is not liable for
any direct, indirect or consequential damages arising out of or resulting
from the use of a NEMO product. The warranties set forth in these terms
and conditions are in lieu of all other warranties, express or implied,
including without limitation, implied warranties of merchantability or
fitness for a particular purpose.
When using a supplamentry pump in combination with the
Integrated Pump (i.e. a bike pump) via the optional input/moisture
release valve be sure not to overinflate the airbeams.
The one-way check valve on the Intgrated Pump can get blocked
with saliva. If this happens, give it a hard shake or use a pen or stick
to release it.
WARNINGS
3
4
5
NEMOID™ FOOT PUMP
To inflate a NEMO airbeam, connect the quick-disconnect fitting on the
end of your Nemoid™ foot pump to the inflate/deflate valve at the base
of the airbeam. When properly connected, there will be an audible click.
Make sure the red Dump Check Valve™ is open. This will allow to air to
refill the pump body after every time you step on it.
When the airbeam is at the correct pressure you will find it very difficult
to compress the pump again. AirSupported Technology™ is a low
pressure system that runs at about 7 psi for a very rigid and strong tent.
The airbeams are strong enough to contain a much higher pressure
than will ever be reached with a NEMO pump.
1
2
Begin applying force to the foot pump by stepping on the pump body;
NEMO shield up. If you are pumping from inside the tent, it may be
easier to use your knee or hand to apply force.
3
4
When the airbeam is at the correct pressure you will find it very difficult
to compress the pump again. Disconnect the quick-disconnect fitting
from the airbeam and return the pump to your stuff sack for storage.
6
5
To inflate a NEMO airbeam with an Integrated Pump, first connect the
quick-disconnect fitting on the end of your pump to the inflate/deflate
valve at the base of the airbeam. When properly connected, there will
be an audible click.
Make sure the optional input/moisture release valve is closed. This
will allow you to fill the pump body with air.
Sqeeze this inflated pouch into the airbeam with your hand. A one-way
valve in the pump will prevent the air from coming back out.
Repeat the cycle of blowing and squeezing until the airbeam is rigid.
After a bit of practice, inflation can become quite quick. Remember to
frequently inhale too!
1
2
While holding the the pump body with one hand and the mouthpiece
to your mouth with the other, blow to inflate the pump body.
3
4
5
INTEGRATED PUMP
2
If you have any problems with a NEMO product, please contact Rainy
Pass Repair, Inc., the industry leader in outdoor product care for repair or
replacement. If you have any questions regarding warranty and repair,
or if you need to send a product in for service, please call Rainy Pass. It is
not necessary to clean the item before sending, but it will be
appreciated if you remove any excessive soiling. Rainy Pass will be
happy to give you advice about safely cleaning your product. Please
provide the following when you send a NEMO product to Rainy Pass:
A note with your name, phone number, address, e-mail and
problem description. A repair form can be downloaded at:
www.nemoequipment.com/pdf/NEMO_repairform.pdf
Please remove all of your personal items and mark all damaged
areas on the product with masking tape.
Pack the product in a sturdy cardboard box with plenty of room. If
possible, use the original box to reduce waste.
If you live in the Seattle area, you can call Rainy Pass locally at (206)
523-8135 and visit their shop during the following hours: M,T,W,F
9am-6pm and Th 9am-7pm.
Ship to:
Rainy Pass Repair, Inc.
5307 Roosevelt Way, NE
Seattle, WA 98105
To contact Rainy Pass:
Phone: 1 (888) 747-7867
Email: [email protected]
www.rainypass.com
REPAIR
5
2
1
3
1
When the beam is fully inflated, disconnect the quick-disconnect fitting
from the airbeam and return the pump to your stuff sack for storage.
For compact packing close the red Dump Check Valve™ and compress.
However, if you are going to be storing your Nemoid™ foot pump for a
prolonged period of time, it should be left uncompressed.
Be careful not to over-inflate if using a supplementary inflation device
through the input valve.
*