Battery charging – ParkZone PKZ3580 User Manual

Page 4

Advertising
background image

5

6

discharging the battery to the soft LVC can still cause permanent

damage to the battery.

If you have any further questions or concerns regarding the handling,

charging and/or use of the included Li-Po battery, please contact Horizon

Support Team at 877-504-0233.

• If at any time during the charge or discharge process the

battery begins to balloon or swell, discontinue charging or

discharging immediately. Quickly and safely disconnect the

battery, then place it in a safe, open area away from flammable

materials to observe it for at least 15 minutes. Continuing to

charge or discharge a battery that has begun to balloon or swell

can result in a fire. A battery that has ballooned or swollen even

a small amount must be removed from service completely.

• Store the battery at room temperature in a dry area for best results.

• When transporting or temporarily storing the battery, the temperature

range should be from 40–120 degrees Fahrenheit. Do not store the

battery or model in a car or direct sunlight whenever possible. If stored

in a hot car, the battery can be damaged or even catch fire.

• Do not over-discharge the Li-Po flight battery. Discharging the

battery too low can cause damage to the battery resulting in

reduced power, duration or failure of the battery entirely.

Li-Po cells should not be discharged to below 3V each under load. In

the case of the 1S Li-Po battery used for the Sukhoi, you will not want

to allow the battery to fall to below 3V during flight.

The Sukhoi receiver unit features a soft low voltage cutoff (LVC) that

occurs when the battery reaches 3V under load. When the soft cutoff

occurs, the ESCs of the receiver unit will reduce power to the

motor (regardless of the power level you have set with the throttle

stick) in order to prevent the voltage of the battery from dropping

below 3V. This reduction in power usually requires that you land the

model immediately, at which point you should power down the model

and unplug the flight battery. And while it is possible to power the

model up and to fly again after the soft LVC occurs, this is NOT

recommended as continued discharging to the soft LVC will cause

permanent damage to the Li-Po battery that results in lost power

and duration when using the battery for subsequent flights, or failure

of the battery entirely. Continued attempts to further discharge the

battery may also result in loss of control while the motor is running

as the voltage of the battery may drop below the minimum operating

voltage of the receiver and other electronics.

Also, it is not recommended that you fly to the soft LVC every time

you fly. Instead, you should be aware of the power level of the

battery/airplane throughout the flight, and if at any time the

airplane begins to require more throttle than typical to maintain

flight, you should land the airplane immediately. Routinely

Battery Charging

It is important that you only charge the included 1S 3.7V 110mAh Li-Po

Battery (PKZ1034) with the included 1S 3.7V DC Li-Po Battery Charger

(PKZ3240) or the previously mentioned E-flite Celectra 4-port Charger

(EFLC1004). Attempting to charge the battery using another Li-Po charger or

non-Li-Po compatible charger could result in serious damage. Please

familiarize yourself thoroughly with the Battery Warnings and Guidelines

section before continuing. Please follow these steps to charge the Li-Po

battery with the included charger:

• Remove the cover on the bottom of the charger and install four of the

included AA batteries, noting proper polarity. Replace the cover after

the AA batteries are installed.

• Slide the battery into the slot on the charger. The endcap of the

battery has been specifically designed to allow the battery to be slid

into the slot easily one way (usually with the label on the battery facing

outward) to prevent reverse polarity connection. However, please be

sure to check for proper alignment and polarity before proceeding to

the next step.

• Gently press the battery and its connector into the charge jack/

connector located at the bottom of the slot in the charger. Again, be

Advertising