ParkZone PKZ6080 - Manual (Page 7)

EN
1. Where installed, remove the battery hatch from the
fuselage.
2. Turn the aircraft over so the bottom of the fuselage
faces up.
3. Where used, connect the aileron, flap and landing
gear connectors to the receiver or Y-harnesses. The
left and right servos can be connected to either side of
a Y-harness.
4. Insert the wing’s guide pins in the fuselage plate
holes.
5. Where used, store the aileron, flaps and retractable
landing gear connectors in the fuselage. Ensure the
connectors do not fall out of the fuselage after the
wing is installed.
6. Align and attach the wing to the fuselage using
2 screws.
CAUTION: DO NOT crush or otherwise damage the
wiring when attaching the wing to the fuselage.
7. Turn the assembled fuselage and wing so the
bottom of the wing is down.
8. Disassemble in reverse order.
1 2 3
• Lower throttle and
throttle trim to
lowest settings.
• Connect battery
to ESC.
Continuous LED
Series of tones
Power on
Transmitter
Wait 5
seconds
NOTICE: Use of CA accelerant on your model can damage the paint. DO NOT wipe accelerant from
the model; instead, let the accelerant evaporate.
3 X 25mm (2)
Arming the ESC Before Flight
If you plan on installing optional flaps or retracts,
you must do so before installing the wing. Please
proceed to the following pages for instructions.
7
Installing a Receiver
Battery Selection and Installation
1. Install your park flyer or full range receiver in the fuselage using hook
and loop tape or double-sided servo tape.
2. Attach the elevator and rudder servo connectors to the appropriate
channels of the receiver.
3. Attach the aileron Y-harness to the aileron channel of the receiver.
4. Attach the ESC connector to the throttle channel of the receiver.
1. We recommend the ParkZone ® 2200mAh 11.1V 25C Li-Po battery
(PKZ1029).
2. If using another battery, the battery must be at least a 25C 2100mAh
battery.
3. Your battery should be approximately the same capacity, dimensions
and weight as the ParkZone Li-Po battery to fit in the fuselage without
changing the center of gravity.
Installing Wing