ParkZone PKZ6080 - Manual (Page 8)

EN
Installing Optional Flaps
1. Install the left and right flap servos ( A)
(PKZ1081 x 2, sold separately) in the wing
pocket using hot glue or double-sided tape.
2. Install the control horns ( B) and plates (C) on
the wing using 2 screws in each horn.
3. Install a connector and clevis in the second
innermost hole of the servo arm and outer hole
of the control horn.
4. On both flaps, carefully cut a wedge of foam
from the flap hinge near the aileron hinge (see
illustration).
5. On both flaps, carefully cut a small amount
of foam at the flap and wing root so the flap
moves freely (see illustration).
6. Very carefully pull up the tape to place the
servo wires in the wing channel ( D).
7. Place the flap servo wires in the wing channel
( D) with the aileron wires.
8. Install the flap servo connectors in the holes at
the wing root on each side.
9. Place tape over the wing channel ( D).
10. Cut a small amount of tape at each flap servo
arm to let the servo arms move freely.
11. Attach the servo connectors to the correct
receiver channels or Y-harnesses.
12. Proceed to wing installation instructions or
landing gear installation instructions.
NOTICE: Ensure the wires are not crushed or
damaged when the wing is attached to
the fuselage.
13. Do a control test of the flaps using your aircraft
and transmitter.
A
D
B
C
If you are not installing flaps or retracts,
please proceed to the Installing the Landing Gear section.
1/2 or Takeoff Flap Full Flaps
Flap down 10mm down 20mm down
Factory Settings
Arms
Horns
Flaps
3 X 15mm (2)
8