Qsonix Integration - Manual (Page 8)

Qsonix Integration Guide
Page | 8
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
TrackCount Specifies the number of tracks to skip forward. This parameter is optional and the
default value is 1.
Previous [Zone #] {TrackCount}
DESCRIPTION
Skips playback backward by {TrackCount} tracks for the specified [Zone].
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
TrackCount Specifies the number of tracks to skip forward. This parameter is optional and the
default value is 1.
Cue [Zone #] [CueLocation]
DESCRIPTION
Cues into the current track to the number of seconds specified by [CueLocation].
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
CueLocation Specifies where the current cue point of the current track should be set. This
should be an integer value specifying the number of seconds from the start of
the track.
Volume [Zone #] [VolumePercentage]
DESCRIPTION
Sets the volume for the specified [Zone] to the [VolumePercentage] specified. To turn the volume up or
down (not set a discreet value, see the VolumeUp or VolumeDown command instead).
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
VolumePercentage Specifies the new volume setting desired in terms of a percent of full volume.
The value must be an integer value between 0 and 100.
VolumeUp [Zone #] [Amount]
DESCRIPTION
Increases the volume for the specified [Zone] by the [Amount] specified.
The VolumeUp command is used to set the volume to a value relative to the current setting, so the
Amount value must be between 1 and 100. Note that if the value specified would cause the volume
setting to be greater than 100, the volume will be set to 100 instead. For instance, if the volume is
currently set to 50% and the VolumeUp command is issued with an Amount parameter of 70, the
volume will be set to 100% (instead of 120%).
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.