Qsonix Integration - Manual (Page 9)

Qsonix Integration Guide
Page | 9
Amount Specifies the amount of volume change desired. The playback volume change
amount is specified in terms of percent (0 to 100%).
VolumeDown [Zone #] [Amount]
DESCRIPTION
Decreases the volume for the specified [Zone] by the [Amount] specified.
The VolumeDown command is used to set the volume to a value relative to the current setting, so the
Amount value must be between 1 and 100. Note that if the value specified would cause the volume
setting to be greater than 100, the volume will be set to 100 instead. For instance, if the volume is
currently set to 50% and the VolumeDown command is issued with an Amount parameter of 70, the
volume will be set to 100% (instead of 120%).
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
Amount Specifies the amount of volume change desired. The playback volume change
amount is specified in terms of percent (0 to 100%).
MuteToggle [Zone #]
DESCRIPTION
Toggles the mute setting for the specified [Zone]. For a discreet version of this command, see
MuteSet.
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
MuteSet [Zone #] [MuteValue]
DESCRIPTION
Sets the mute setting for the specified [Zone] to a discreet value specified by the [MuteValue]
parameter.
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.
MuteValue Specifies the desired new state of mute. The value must be either On or Off.
RepeatToggle [Zone #]
DESCRIPTION
Toggles the repeat setting for the specified [Zone]. For a discreet version of this command, see
RepeatSet.
PARAMETERS
Zone # Specifies which zone should be acted upon. Must be 0 or a valid zone number.