Qsonix Q100 System User Manual
Page 9
9
h
Note: The Q100 can only operate in two-zone mode when connected using analog outputs.
Step by Step cabling guidelines
1.
Open the monitor stand (use fold switch), so you can locate the monitor on a flat surface suc
as a tabletop, on top of the Q100 unit or other suitable location. (Unit can be wall-mounted
with optional mounting kit and professional installation – contact your Qsonix dealer)
2.
Connect AC power cable to touchscreen power adapter.
3.
Connect DC 12V mini connector from power adapter to rear of touchscreen DC 12V input.
4.
Connect one end of the D-sub 15-pin VGA signal cable to the “Video” connector on the Q100
unit and the other end to the “VGA Input” connector on the back of the touchscreen.
5.
Connect the DB-9 (square) end of the RS-232 signal cable to the “Touchscreen” connector on
the back of the Q100 unit, and the other end (round plug) to the serial/touchscreen connector
on the back of the touchscreen.
6.
Connect the Network port on the rear of the Q100 to your Network router, hub or switch using
a CAT5 Ethernet cable. (You may also use a 3
rd
party passive Wireless bridge)
7.
Using the supplied audio cables, connect the appropriate analog and digital outputs to the
line-level inputs of your amplifier, preamplifier or powered speakers.