RODE Microphones NT1000 - Manual (Page 6)

- 6 -
The stand-mount includes a thread adaptor
allowing connection to either 3/8” or 5/8”
stand thread.
• Always use a high quality microphone cable and
ensure that it is wired Pin 1 screen, Pin 2 (+), Pin 3 (-).
• We recommend that any connections made to the
mixer or recorder are made with the attenuation
(gain) set to OFF.
• When fi rst switching the mixer on and phantom
power has been applied to the NT1000 you should
allow several seconds for the microphone to
stabilize.
• To ensure the lowest noise/distortion your mixer
input gain control should be set so that the Peak
Program Indicator (PPI) LED fl ashes ON during
peaks of the source (voice/instrument).
If there is no PPI, adjust the input gain while
listening for distortion of the sound. If distortion is
heard, gradually reduce the gain until it is no longer
present.
• Microphone technique, or how to get the sound
you want, requires experimentation.
We suggest that you start with the channel EQ
set to ‘OFF’ or ‘FLAT’ (no boost or cut). Try to get
the sound you want by placing either refl ective or
absorbent panels at various angles adjacent to the
source being recorded.
Using the NT1000