Remy 42MT Universal User Manual
Remy Generators
Instruction Sheet
10532028
15JL13 C/P30500 REV2
NOTICE
- Only licensed Remy International, Inc. product and component parts should be used, and the use of other parts or modifications not approved
by Remy International, Inc. will void all applicable warranties. The failure to carefully follow these Installation Instructions, set forth above, will void all
applicable warranties. DELCO REMY is a registered trademark of General Motors Corporation, licensed to Remy International, Inc. Pendleton, IN 46064.
©
2012 Remy International, Inc. All rights reserved
1
Technical support: USA 800 854 0076, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 2106 6510 or visit
delcoremy.com
37MT
™, 41MT™ &
42MT
™ UNIVERSAL SPARE PARTS INSTRUCTIONS
This package contains various seals, insulators and hardware parts necessary to replace worn or missing parts.
WARNING!!!
ALWAYS USE PROPER EYE PROTECTION WHEN PERFORMING ANY MECHANICAL REPAIRS TO A VEHICLE
–
INCLUDING, BUT NOT LIMITED TO, ANY INSTALLATION AND OR REPAIRS TO THE DELCO REMY STARTING MOTORS.
FAILURE TO USE PROPER EYE PROTECTION CAN LEAD TO SERIOUS AND PERMANENT EYE DAMAGE.
Only perform the mechanical functions that you are properly qualified to perform. Mechanical repairs that are beyond your te chnical
capabilities should be handled by a professional installation specialist.
FOLLOW ENGINE AND/OR VEHICLE MANUFACTURER'S INSTRUCTIONS CAREFULLY WHEN REMOVING AND INSTALLING
THE STARTER.
INSTRUCTIONS FOR REPLACING SPARE PARTS
DANGER!!!
ALWAYS DISCONNECT BATTERY GROUND BEFORE REMOVING OR REPLACING CABLES AT THE STARTER.
FAILURE TO DISCONNECT THE BATTERY GROUND CABLE CAN LEAD TO SERIOUS INJURY.
1.
Remove vehicle leads connected to the starter, noting their positions for reinstallation of starter, and remove starter.
2.
Reinstall starter and connect cables and other leads, as removed.
3.
Reconnect the negative (-) cable at the battery
NOTICE! Instructions for replacing any of these parts can be obtained from our websiteAll major
components have detailed instructions for removal and replacement of each component’s parts.