Remy 39MT STARTERS HARDWARE PACKAGES - Manual

Instruction Sheet
10526606
15JL13 C/P30500 REV3
NOTICE - Only licensed Remy International, Inc. product and component parts should be used, and the use of other parts or modifications not approved
by Remy International, Inc. will void all applicable warranties. The failure to carefully follow these Installation Instructions, set forth above, will void all
applicable warranties. DELCO REMY is a registered trademark of General Motors Corporation, licensed to Remy International, Inc. Pendleton, IN 46064.
©
2012 Remy International, Inc. All rights reserved 1
29MT, 38MT & 39MT STARTERS HARDWARE PACKAGES
These packages contain universal hardware parts for repairing both 12 volt and 24 volt 29MT, 38MT and 39MT starters.
NOTE: It is beneficial and possibly necessary to obtain one of these hardware packages for reassembly of the starter. It is preferable to
use new, undamaged parts
WARNING!!! ALWAYS USE PROPER EYE PROTECTION WHEN PERFORMING ANY MECHANICAL REPAIRS TO A VEHICLE –
INCLUDING, BUT NOT LIMITED TO, ANY INSTALLATION AND OR REPAIRS TO THE DELCO REMY STARTING MOTORS.
FAILURE TO USE PROPER EYE PROTECTION CAN LEAD TO SERIOUS AND PERMANENT EYE DAMAGE.
Only perform the mechanical functions that you are properly qualified to perform. Mechanical repairs that are beyond your technical
capabilities should be handled by a professional installation specialist.
FOLLOW ENGINE AND/OR VEHICLE MANUFACTURER'S INSTRUCTIONS CAREFULLY WHEN REMOVING AND INSTALLING
THE STARTER.
DANGER!!! ALWAYS DISCONNECT BATTERY GROUND BEFORE REMOVING OR REPLACING CABLES AT THE STARTER.
FAILURE TO DISCONNECT THE BATTERY GROUND CABLE CAN LEAD TO SERIOUS INJURY.
FOR ADDITIONAL INFORMATION, EXPLODED PARTS VIEWS OF 29MT-38MT-39MT STARTERS ARE AVAILABLE ON
www.delcoremy,com WEBSITE UNDER PRODUCTS AND SERVICE PARTS.
39MT PACKAGE CONTENTS
Description Part # QTY Torque Values
Insulation Plate 10511772 1
Insulator 10511778 1
Insulator Ground 10511774 1
Solenoid G, B+ and M Terminals Nut 10510842 4
Ground Terminal - 24.5-27.5 Nm (18-20 lb ft)
Solenoid B+ terminal - 24.5-27.5 Nm (18-20 lb ft)
Terminal M - 19.6-22.5 Nm (14-16 lb ft)
CE Nut 10517145 1 7.0-11.0 Nm (62-97 lb in)
Solenoid S Terminal Nut 10517133 1 2.0-2.5 Nm (18-22 lb in)
O-Ring 10511947 2
O-Ring 10511771 2
O-Ring Ground 10511770 2
Spacer 10516837 1
Washer 10517132 1
Washer 10511775 2
Insulator Sheet 10525469 1
Pinion Retainer GenII Starters 10511745 1 24.4 mm outside diameter
Pinion Retainer GenIII Starters 10518711 1 28 mm outside diameter
Ring Pinion GenII Starters 10511746 1 16.5 mm internal diameter
Ring Pinion GenIII Starters 10518712 1 19.1 mm internal diameter
Bolt IMS 10517131 2 7.7-9.8 Nm (68-86 lb in)
Bolt Solenoid 10516836 2 7.7-9.8 Nm (68-86 lb in)
Sol. Ground Lead Screw 10516966 1 2.0-2.5 Nm (18-22 lb in)
Roll Pin DE Housing 1875690 1
Spring Washer Solenoid 10517139 1
Roll Pin Shift Lever 10511666 1
Solenoid Ground Lead 10511796 1
JSP Nut 10516969 1 2.0-2.5 Nm (18-22 lb in)
Tie Wrap JSP 10512026 1