Rocktron BASS200 - Manual (Page 7)

BASS Control
This control provides a 15dB of cut or boost at 100Hz. Rotating this control clockwise will
increase the lower frequencies and, depending on other settings, will generally make your tone
warmer and heavier.
MID-LOW Control
This control provides approximately 15dB of cut or boost at 220Hz.
MID (MIDDLE) Control
This control allows your getting 15dB of cut or boost at 660Hz. Turn it clockwise, the sound
will be fatter and more powerful.
MID-HI Control
This control provides approximately 15dB of cut or boost at 1.6K Hz.
TREBLE Control
This control provides a 15dB of cut or boost at 5k Hz. Rotating this control clockwise will
increase the high frequencies producing a brighter sound.
COMPRESSOR Control
This controls the amount of signal compression. At the full counterclockwise position there is
no compression. At the full clockwise position there is full compression. The sonic effect of
compression is reduced dynamics, increased sustain and a more consistent output level regard-
less of how light or hard the strings are played.
VOLUME Control
This control determiners the overall level (output) of the amplifier.
POWER - On/Off Switch
This turns the amplifier on and off. When the switch is “lit” then the amplifier is “on”.
COMPRESSOR Button
Use this switch to turn ON or OFF the Compressor.
SEND Jack
Use this 1/4″ unbalanced jack to send signal to a professional outboard effects processor. Out-
put level is approximately 0 dB to +4 dB and is post-EQ and post-shape but unaffected by the
setting of the volume control. It can also be used as a Line Out jack if required.
RETURN Jack
Use this 1/4″ unbalanced jack to return signal from a professional outboard effects processor.
This jack can also be used as a Line In Jack if required.
LINE OUT Jack
Use this jack for recording, direct to a PA system, or to a power amplifier.
8
9
10
11
12
13
14
15
16
17
18
19