Rocktron Rampage R50 C - Manual (Page 6)

2
Front Panel
1
2
3
4
5 6 7
8
9
10 11 12
INPUT jacks - HIGH and LOW
Connect the output of your guitar into one of the two 1/4" input jacks
with a shielded guitar cable. Select the HIGH input jack for extra gain,
or the LOW input jack for normal gain.
GAIN controls (CLEAN and OVERDRIVE)
Adjusts the amount of amplification in the preamp section. More gain
increases distortion, reduced gain results in a clean sound.
OVERDRIVE is designed with increased gain while CLEAN has less
built-in gain.
CH. SELECT push button
Channel Select - CLEAN or OVERDRIVE. LED indicators show
which channel is Active.
LEVEL controls (CLEAN and OVERDRIVE)
The LEVEL controls adjust the overall volume for each channel.
Once the gain is set, adjust the LEVEL control for the appropriate
listening volume.
EQUALIZER - HIGH/MID/LOW controls
Tone controls, or EQ. LOW boosts or cuts low frequency, or bass
sound. HIGH does the same for the treble frequencies. MID adjusts
the midband frequencies.
PRESENCE control
Increasing the amount of PRESENCE (turning the knob clockwise)
will increase the definition of the notes played.
REVERB control
Adjusts the amount of reverb added to your guitar's signal. Turning
the knob clockwise increases the level of the effect.
CHORUS ON push button
Two position push button. Push IN to activate CHORUS. When
pushed again, CHORUS is shut off.
5
3
1
2
4
6
7
8