Rocktron Rampage R50 C - Manual (Page 7)

3
5 0C
CHORUS DEPTH and RATE
These two controls affect the depth or amount of chorus and the rate
or speed of the chorus sweep. A lower DEPTH setting will produce a
more subtle detune effect, while a higher setting will produce a more
extreme detuning effect. Lower RATE settings will result in slower
sweep speeds. A higher setting will result in faster speeds.
PHONE (Headphone) jack
Plug your headphones into this jack to bypass the power amp and
practice in private.
POWER switch and LED
Switch turns the amp ON and OFF. A red LED shows the amp is ON.
9
10
11
1 2 3
1
2
3
SPEAKER OUTPUTS (RIGHT and LEFT)
Connect one additional 8 ohm cabinet per jack. If more are connected,
you will damage your amp!
LINE OUTPUTS (LEFT and RIGHT)
1/4" jacks allow connection to other equipment like mixers, tape
recorders or amplifiers. LEFT and RIGHT outlets are provided to
maintain the stereo chorus effect.
FOOTSWITCH INPUTS (CHANNEL and CHORUS/REVERB)
Remote control CHORUS ON/OFF, CHANNEL selection and REVERB
ON/OFF. To control CHANNEL selection , plug a single footswitch*
into the CHANNEL input. To control CHORUS and REVERB ON/OFF,
use a double footswitch* with a stereo 1/4" jack in the CHORUS/
REVERB input.
* Rocktron Rampage single (RFS1) and double (RFS2) footswitches are
available and sold separately.
Rear Panel
AGX™ (Automatic Gain Expander)
Rocktron's patented AGX™ system solves the long standing problem encountered by guitar players
when using high gain distortion. The AGX™ circuit expands the gain of the amplification circuit only when
required based on the input level. When no signal is present, the AGX™ circuit expands down the amplifi-
cation level to a point where hum and noise are dramatically reduced.