Rocktron Reaction HUSH - Manual (Page 5)

Here’s more HUSH tips: For maximum noise reduction
results, place the Reaction HUSH after your distortion and
modulation effects (chorus, flanger, phaser, etc.) but before
any delay or reverb effects. If you are already comfortable
rolling back your guitar’s volume pot, simply turn your
distortion and other effects in the chain before the HUSH
to “ON”, roll back your volume pot, adjust the HUSH
Threshold control to remove any hiss you hear, and you are
ready to go!
Make sure you pay attention to the proper setup by placing
the Reaction HUSH AFTER your noisy stomp boxes or
in your amp’s effects loop. The Reaction HUSH is NOT
designed to take the input directly from your guitar WITH-
OUT some processing happening between the guitar and
the noise reduction. When setup correctly, with your signal
going from your preamp and effects, or from your distortion
and effects, into the Reaction HUSH, you will love how
it cleans up the excess noise, including pickup buzz! The
Reaction HUSH can also be used in your amplifier’s effects
loop. However, if you are running multiple effects through
this loop, the HUSH should always be the last dynamic de-
vice in the signal chain, but before digital delays or reverbs.
The Reaction HUSH will give you the same great HUSH
noise reduction used by thousands of high profile artists for
years! Add true bypass and the Reaction HUSH becomes a
great addition to any pedal board.
The footswitch on the Reaction HUSH controls On/Off sta-
tus as shown by the LED indicator. Reaction stomp boxes
run on a 9V Alkaline battery, or may also be powered by
Rocktron’s DC OnTap Universal Power Supply adaptor.
Introduction continued....