Denon AVR-1907 - Manual (Page 14)

Easy Setup Procedure Easy Setup Procedure
11
ENGLISH
ENGLISH
Front A, Front B:
Assign to use the “Front A” or “Front B” speakers with bi-amp
connections.
Surround Back:
Assign to use as surround back speaker.
When assigned to “Front” or “ZONE2”, skip the surround back
channel measurement.
During the auto setup procedure, test tones are not output to
“ZONE2”.
ZONE2:
Assign to use as “ZONE2” speakers.
t Switching the front speaker
Press D D H H to select “Front Sp”, then press F F G G to select
the speaker.
Front A Front B Front A+B
y Starting Auto Setup
Press D D H H to select “Start”, then press F F .
• Start the measurements.
Measurement of each channel is performed as follows:
FL FR C SW SL SR SBL SBR
1 2
1: The subwoofer speaker is measured twice.
2: Not displayed when “ZONE2” and “Front” are set at
“Setting the Power Amplifier Assignment” ( page 53).
After each channel is measured, “Calculating” appears.
The display switches to the Auto Setup check screen
automatically.
NOTE:
• Do not change the speaker connections or subwoofer volume
after making the measurements.
• Do not turn off the power while the data is being stored.
Cautions during measurements:
• Loud test tones are output during the measurements. Be careful
for example when small children are nearby.
• Proper measurements may not be possible if there are obstacles
between the speaker and the setup microphone.
• During the measurements, do not stand between or near the
speakers and setup microphone.
• To avoid influencing the measurements, turn off the power of air-
conditioners or any other equipment producing sound in the
room. Perform the measurements with the room as quiet as
possible.
• Measurement is cancelled when VOLUME is operated while the
Auto Setup is performed.
e Perform the Auto Setup procedure
Press D D H H to select “Auto Setup”, then press ENTER .
Press SYSTEM SETUP .
Press D D H H to select “Auto Setup”, then press ENTER .
The message “Connect Microphone” is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
1
2
3
• “System Setup” menu is not displayed when using headphones.
1
2
3
r Assigning power amplifiers
Press D D H H to select “Power Amp Assign”, then press F F
G G to set.
The surround back output can be assigned to the “Front” or “ZONE2”
output.
¢ About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to two times. During this time,
“Retry1” or “Retry2” is displayed on the screen.