Rocktron Mike Orlando Signature Wah - Manual (Page 10)

5
6
7
8
9
Controls and Function Descriptions - Cont.
INPUT Jack - using a standard guitar cable - plug your guitar
into this jack.
9-VOLT ADAPTER INPUT - This receptacle requires a 9V
DC adapter (not included) with a 2.1mm coax plug to provide
power to the unit. Please consider using the Rocktron DC
OnTap adapter (sold separately) available from your Rocktron
dealer.
Note: If an adapter other than the Rocktron DC OnTap adapter is used, it needs to be a 9V
DC filtered audio grade type with a current rating of 100ma or greater . The plug is a 2.1mm
Coax jack (Tip is Negative and Sleeve is Positive). Please follow all instructions that appear
on the bottom of the Mike Orlando Signature Wah.
OUTPUT Jack - using a standard guitar cable, plug this out-
put into the next effect in your effect chain or directly into the
input of your guitar amplifier.
WAH ON LED - The red LED will be lit when the “wah” effect
is activated. To activate the wah - see point 2. The red LED
will not be lit when the wah is bypassed.
PEDAL ROCKER TENSION ADJUSTMENT - This screw will
allow you to adjust the “action” of the pedal to suit your taste
with the included allen wrench. If you would like a tighter or
heavier movement of the pedal using an allen wrench turn the
screw clockwise. This will increase the torque and tension on
the rocker pedal. If you would like a smoother or softer pedal
movement turn the allen screw counter-clockwise. This will
loosen the tension on the pedal pivot point.