Rocktron Utopia G200 - Manual (Page 52)

52
8. Operation Mode
The Utopia G200 has two OPERATION MODES - Preset and 2nd. When in Preset mode you can
select any preset you would like in the various banks. When in 2nd Mode you are in the 2nd function
mode of the selected preset. The 2nd Function mode allows you to turn on and off various aspects of
the preset.
In the PRESET MODE the LEDs on the pedal board will be lit "GREEN".
When in this mode you can select any preset in any bank that you would prefer.
PRESET MODE
2ND FUNCTION
MODE
To enter into the 2ND FUNCTION MODE, press the "2nd" button. The LED
above the 2nd Button will turn "RED". Once in the 2ND FUNCTION MODE
you can turn on and off the assigned Effect, MUTE/TUNER and the TAP Delay
function with the selected preset.
Here is a list of those effects that can be accessed within each preset in the 2ND
FUNCTION MODE:
1
2
3
Exit 2nd Function
EFFECT ON/OFF - turns on or off the assigned effect to that footswitch, either
Bypass, Toggle, Solo, Compressor, Modulation Effect, Delay, Reverb Input or
Tru-Bypass (one must be set & stored in the Footswitch Mapping Function).
Bypass Effect bypass - turns on or off all the effects and bypasses
them completely.
Toggle Channel Toggle - allows you to toggle between two dif-
ferent channels (for example, between Clean and MEGA)
SOLO Solo Boost - allows a 4db boost in output, ideal to get a
boost when soloing
Compressor Turns on and off the Compressor within the preset.
MOD EFX Turns whatever Modulation Effect (Chorus, Pitch Shift,
Flanger, Tremolo) you have assigned on or off.
Delay Turns on and off the Delay within the preset
Reverb Input Turns on and off the Reverb (Active or Muted)
TBypass Tru-Bypass - turns on and off the effects and preamp and
allows the signal to pass through the G200 unaffected.
MUTE/TUNER - pressing this button will MUTE the output and turn on the
built-in Tuner so that you can tune in silence.
TAP - this button allows you to set the delay rates by tapping this button at the
tempo desired.
2ND - pressing the button again takes you OUT of the 2nd Function mode and
return to PRESET MODE
BUTTON NUMBER 2ND FUNCTION