Rocktron Utopia G200 - Manual (Page 7)

7
STEP 1 Turn ON the UTOPIA G200.
STEP 2 Select your desired preset by pressing any button 1-3 to select presets. You
may also do this by following STEP 6. NOTE - the G200 starts with preset
number 1, preset 0 does not exist.
STEP 3 Scroll through the different preset banks by pressing the UP button (Bank by 3).
You may also reach your desired preset by following STEP 6.
STEP 4 Scroll through the different preset banks by pressing the DOWN button (Bank
by 3). You may also reach your desired preset by following STEP 6.
STEP 5 Use the built-in expression pedal to change the parameter(s) in real time that
are assigned to the pedal controllers function.
STEP 6 You may also select a preset by turning the PRESET SELECT knob.
STEP 7 Turn the FUNCTION SELECT knob to the desired effect or utility function.
STEP 8 Turn the PARAMETER SELECT knob to the parameter you wish to alter under
the selected effect or utility function.
STEP 9 Use the PARAMETER ADJUST knob to modify a parameter value.
STEP 10 After editing any function parameter press the STORE button to start the
storing procedure. The display will toggle and flash "STORE AT PRESET."
If you wish to save the altered preset in the current preset location, press the
STORE button a second time. If you wish to store the altered preset in a differ-
ent preset location, turn the PRESET control to the desired preset number, then
press STORE a second time. Anytime you wish to cancel the store process just
turn the PARAMETER ADJUST one click.
STEP 11 To enter the "2ND Function" mode, press the "2nd" switch, this will turn on a
RED LED above the 2nd button. You can now turn On/Off functions within
that preset using the buttons marked 1-3 (Effect On/Off, MUTE/TUNER and
TAP). When in 2nd mode, the LEDs above the buttons 1 and 3 will light "yel-
low" and the MUTE/TUNER "red". Use the same switch marked "2nd" to
cancel and exit the 2nd Function mode.
Quick Reference....continued...