SkyRC RS16 180W/16A Balance Charger/Discharger - Manual (Page 13)

NiMH 2.0A 9.52V
AUT 000:13 00000
CHARGING / BATTERY IN RE-PEAK
CHARGE MODE
NIMHNICAD
Re-peak Charge Mode (NiMH and NiCad batteries only): In re-peak
charge mode, the charger can peak charge the battery once, twice or
three times in a row automatically. This is good for confirming the
battery is fully charged, and for checking how well the battery receives
fast charges. A five minute cool-off delay occurs after each re-peak
charge. To start charge, move the joystick right and hold it for 3 seconds.
NIMH/NICAD BATTERY PROGRAM
The screen displays the current state of
charging.
To stop the process, move the joystick left.
The audible sound indicates the end of
process.
Elapsed
time
Charged
capacity Battery
type Charge
current
Battery
voltage
NiMH RE-PEAK
1
NiMH 2.0A 9.59V
RPC 000:33 00017
Re-peak cycle number 1 shows on the display.
Move the joystick right to make the re-peak
cycle number blink and then move the joystick
up/down to find the desired number of times to
re-peak charge the battery.
Move the joystick right to confirm selection.
Battery
type
Charge
current Battery
voltage
Elapsed
time Charged
capacity
DISCHARGING OF / BATTERY NIMHNICAD
NiMH DISCHARGE
0.1A CUT:1.0V
Battery
type
Set discharge current on the left and final
voltage on the right. The discharge current
ranges from 0.1 to 8.0A and the final voltage
ranges from 0.1 to 25.2V. To start the
process, move the joystick right and hold it
for 3 seconds.
UP DOWN
- +
RIGHT
UP DOWN
- +
> 3 seconds LEFT RIGHT
CHARGE/DISCHARGE & DISCHARGE/CHARGE CYCLE
OF NIMH/NICAD BATTERY
Battery
type
Elapsed
time Battery
voltage Discharged
or charged
capacity
Discharge
or charge
current
NiMH CYCLE
CHG＞DCHG 1
NiMH 1.0A 7.42V
C>D 022:45 00890
You can set up sequence on the left and the
number of cycles on the right. Range of the
cycle number is 1-5.
Move the joystick left to stop program, you
can move the joystick up/down to alter the
current.
NIMH/NICAD BATTERY PROGRAM
Discharge
current
Battery
type Battery
voltage Elapsed
time
Discharged
capacity
NiMH 0.1A 7.42V
DSC 022:45 00890
The screen indicates the discharging state.
You can move the joystick up/down to alter
discharge current and move the joystick
right to store the value. Move the joystick left
to stop discharging.
The audible sound indicates the end of
process.
> 3 seconds
UP DOWN
- +
UP DOWN
- +
LEFT RIGHT