Speck Electronics SSM - Manual (Page 14)

Specifications (Cont.)
9
Residual Noise Measurement
(Synth In to Program Out) -82dBu
Test Conditions:
-10dBu signal at synth input.
Input slide fader set to #10 position.
Pan pot centered.
Adjust program master to indicate 0VU (+4dBm)
at program feed jack-left.
Input signal removed and terminated with 10k
ohms.
Noise measured at program feed-left with a
unweighted filter.
Power requirements (Mixer)
Power requirements (Power Supply) Bi-polar 16.5 volts DC, 1.3 Amp
120 VAC, 1.0 Amp
Dimensions - SSM Main Unit
Dimensions - SSM Expander
Dimensions - Power Supply HxWxD = 15.75" x 19" x 4.25"
(400mm x 483mm x 108mm)
HxWxD = 15.75" x 19" x 4.25"
(400mm x 483mm x 108mm)
HxWxD = 3.75" x 11.25" x 5.25"
95mm x 286mm x 133mm)
Shipping weight - SSM Main Unit
Shipping weight - SSM Expander
Shipping weight - Power Supply Approximately 32 lbs (14.4Kg)
Approximately 30 lbs (13.5Kg)
Approximately 10 lbs (4.5 Kg)
Low Band Equalization
Mid Band Equalization
High Band Equalization 50Hz-500Hz, 15dB Boost or Cut
500Hz-5kHz, 15dB Boost or Cut
5kHz-15kHz, 15dB Boost or Cut
Chapter 1 Introduction Section